RE: My test to date
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: My test to date




Rich Kinsley wrote:
> 
> 
> 
> Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
> 
> Today I ran the engine at idle for almost a half hour. It got up to 
> probably 185deg. Not bad. The fuel pressure started at 6.5psi and after 
> about 5 minutes it started to drop. It wound up about 3.5psi. I couldn't 
> 
> get a container around the regulator so my stepson wet down 3 shop 
> towels and put them in the freezer. When they were good and stiff we 
> wrapped them around the regulator. The pressure did not increase. 
> Actually it went down just a bit. The regulator felt very cool too. He 
> crawled under and said the pump motor was too hot to touch but the pump 
> end wasn't too bad.
> 
> I have a second gauge and adapter coming so I can put it ahead of the 
> regulator and see if the pressure drop is indeed on the pump side. We'll 
> 
> see where we go from here.

Rich,

This may have been covered already, but what type of gas cap are you 
running? An aftermarket vented cap that isn't venting properly will 
cause the problem you are having. 

Dave Walters
Aurora, Co.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.