Re: hood scoop

["Gary H." <spigot2039@xxxxxxxxxxx>]

There was a member here a few years ago who had a template to use to position the hood scoop. Unfortunately he lent the template to someone on this list and never got it back. :( 

Seems I recall you position the back of the scoop 1" away from the back of the hood. Someone correct me if that is incorrect.

I have a fiberglass scoop I can measure. I assume it is correct. I bought it at a swap meet years ago and don't know who manufactured it. 

Don't know about the aluminum gauge.

Thanks,
Gary H.



-----Original Message-----
 
>hi all
>thanks to everyone for their great imput .question for those that have done this in the past.
>also for those that may do it in the near future.
>is there diminsions some where to make a hood scoop for a 63 dodge.also if i wanted to make it out of aluminium what (GAUGE) should be used.
>thanks jack
>63 dodge polara 500 hard top
>446 with max wedge top end 
> 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.