RE: Engine Turned pattern on '64 Sport Fury side trim

[Jeff Adams <ledman_70@xxxxxxxxxxx>]

I kinda like the smaller turned roll on the last line. Dirt cheap price 
and 1 roll is plenty, IF it's close enough.

Jeff Adams wrote:
> 
> I just found this...you guys think this is close enough? I need the same 
> 
> kind of trim to clone my 64 Polara into a 500 model.
> http://www.thefind.com/family/info-engine-turned-sheet
> spigot2039@xxxxxxxxxxx wrote:
> > 
> > 
> > This? 
> > 
> > http://www.lategreatchevy.com/product.asp?pf_id=537001&dept_id=1492
> > 
> > Thanks,
> > Gary H.
> > 
> > 
> > -----Original Message-----
> > 
> > >Try as I might, I could not find a supplier for the aftermarket tape 
> > >with machining. If someone has a link or source, please send it along. 
> > >
> > >
> > >
> > >Good to hear from you Ron! 
> > >
> > >
> > >
> > >Thanks/ Butch/Ferndale, WA 
> > >
> > > 
> 
> 
> 
> Jeff Adams
> 64 Polara



Jeff Adams
64 Polara


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.