RE: Looking for a Speedometer drive gear, 19 tooth for a 1960 Chrysler

["Gary H." <spigot2039@xxxxxxxxxxx>]

Might try Pat Blais Transmissions that is listed on the "1962 to 1965 Mopar Vendor and Parts Sources" page on the 62-65 site. 

I'm thinking it used the same drive gear as our PB aluminum TF versions; the '60 had a cast iron TF, if I recall right.

Thanks,
Gary H. 

-----Original Message-----
 
>Is that a different one than ours for our years? 
>
>Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
>====================================================================
>                 Gary Pavlovich wrote:
>> 
>> 
>> Does anyone know where to obtain a 
>> 19 tooth speedo drive gear for a 1960 Chrysler?
>> The drive gear housing has a total length of 2 7/16".
>> 
>> If the 19 tooth is not available I suppose I could use a substitute.
>> 
>> Any help is appreciated.
>> 
>> Thank you,
>> Gary Pavlovich 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.