Console Tach

[John <jswask@xxxxxxx>]

I'm thinking of putting a stock tach into my console (64 sport fury) I have 3 tachs and 1 sending unit. Haven't checked to see if the tach's work yet. But my question is. I have the wire harness that goes to the sending unit to the tach. But don't have the harness that goes into the bulkhead, then to the distrib,and coil.  And there is no diagram shown in my factory repair manual. I have the wire diagram to a sun tach. So i can hook i up, just want to make it look correct. Looking for this wire harness. Haven't even seen one.             Thanks John Wask... 		 	   		  
_________________________________________________________________
Hotmail has tools for the New Busy. Search, chat and e-mail from your inbox.
http://www.windowslive.com/campaign/thenewbusy?ocid=PID27925::T:WLMTAGL:ON:WL:en-US:WM_HMP:032010_1
--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.