Re: Pete Jackson gear drive

[Donnie Schanz Jr <dcs426@xxxxxxxxxxxxxx>]

The cam gear and crank gear go on just as normal. The idler gears only go on 
one way. There is usually a stop button on one side to keep them from 
walking back and forth. Other than that its a simple as pie. I run one in my 
Maxxie and  I got one of theose "Hamster" units in my 409.

Thanks
Donnie
----- Original Message ----- 
From: "Jeff Adams" <ledman_70@xxxxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Sunday, April 04, 2010 11:19 AM
Subject: Pete Jackson gear drive


> I'm getting ready to install a Pete Jackson gear drive in my 426 wedge
> and wondered if anything special is necessary? Anybody know where I can
> find installation instructions? All I have found so far is for Chevy,
> but my gear drive doesn't look anything like their hamster drive!
> Thanks
>
>
>
> Jeff Adams
> 64 Polara
>
>
> ----
> Please address private mail -- mail of interest to only one person --  
> directly to that person.  I.e., send parts/car transactions and 
> negotiations as well as other personal messages only to the intended 
> recipient, not to the Clubhouse public address. This practice will protect 
> your privacy, reduce the total volume of mail and fine tune the content 
> signal to Mopar topic.  Thanks!
>
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and 
> http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.