Re: '64 Plymouth Bumpers

[Rich <ssplymouth@xxxxxxx>]

  Dave,

Make sure bolt hole on each end of rear bumper are lined up with center of Fury tail lights. IF the bolt hole is lined up closer to outer edge of tail lights it is a 63 or 65 rear bumper NOT a 64.

Rich,
64 MW Belve 4 spd
-------------- Original message ----------------------
From: Dave64 <lt7dave@xxxxxxxxx>
>
> 
I'm looking at possibly buying a pair of bumpers from a '64 Fury that have the 
bumper bars on them.  I don't want the bars for my Belvedere.  If I remove them, 
are there going to be holes that don't belong for my Belvedere?  Or are they 
holes I already have in my existing bumbers that just have bolts in them?  I 
> can't look at these bumpers in person - just have pics to go from.
> 
> Thanks,
> 
> Dave
> 
> 
>       
> 
> 
> ----
Please address private mail -- mail of interest to only one person -- directly 
to that person.  I.e., send parts/car transactions and negotiations as well as 
other personal messages only to the intended recipient, not to the Clubhouse 
public address. This practice will protect your privacy, reduce the total volume 
> of mail and fine tune the content signal to Mopar topic.  Thanks!
> 
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and 
> http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 
> 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.