Re: rear end rubber snubber

[Gary Pavlovich <glpavlovich@xxxxxxx>]

Butch,

Just realized you only need the rubber bushing; probably use the repro 
suspension snubber and affix it to the plate via bolt/screw and/or and 
industrial killer adhesive.

Gary
----- Original Message ----- 
From: "Butch Edison" <waedison@xxxxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Saturday, June 19, 2010 7:29 AM
Subject: rear end rubber snubber


> The car is a 1964 Plymouth Sport Fury with the original tapered axle rear 
> end. I need the rubber snubber that goes on top of the plate above the 
> U-joint. It looks like the snubber base attaches to the plate with two 
> steel clips. Do we have a source for these, or one where I can drill a 
> hole and bolt one on? Thanks/Butch/Ferndale, WA
>
>
> ----
> Please address private mail -- mail of interest to only one person --  
> directly to that person.  I.e., send parts/car transactions and 
> negotiations as well as other personal messages only to the intended 
> recipient, not to the Clubhouse public address. This practice will protect 
> your privacy, reduce the total volume of mail and fine tune the content 
> signal to Mopar topic.  Thanks!
>
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and 
> http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.