Re: Victor Heads and Distributor Clearance

[Dodger7998@xxxxxxx]

How much higher would the top section of the distributor have to be  to 
clear the head,,,,,,,,,,,,,,,,,,,,,, would it be possible to extend the shaft  
on the dist. and put a spacer under it?????? just a thought
 
 
In a message dated 7/12/2010 8:45:31 A.M. Central Daylight Time,  
nover@xxxxxxxx writes:


Anyone out there running the Edelbrock/Procomp Victor heads on  and RB? If 
so 
what distributor are you using? The procomp distributor I  have on is 
hitting 
the corner of the head with cap clips and the MSD  distributor I want to 
use 
is even wider than the Procomp. There is enough  meat on the corner of the 
head to grind some metal off but I really don't  want to do that unless it 
is 
the only option left. Any suggestions would  be greatly appreciated.
Nico Over
Va. Beach, Va.
1963 Dodge  330
1964 Plymouth SF 451
195 Plymouth Bel II  convert


----
Please address private mail -- mail of interest to  only one person -- 
directly to that person.  I.e., send parts/car  transactions and negotiations as 
well as other personal messages only to the  intended recipient, not to the 
Clubhouse public address. This practice will  protect your privacy, reduce 
the total volume of mail and fine tune the  content signal to Mopar topic.  
Thanks!

1962 to 1965 Mopar  Clubhouse Discussion  Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and  
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.  




--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.