Tuning a road demon 625 cfm carb
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Tuning a road demon 625 cfm carb



Am re-posting as I did this first from my cell phone and am not sure
it posted properly ...

I talked to a tech at Barry Grant about tuning my 625 cfm road demon
on my poly 318. I get black smoke whenever I floor it. He asked me
three things - timing at idle, vacuum at idle and cam duration at .050

Timing is 12 degrees btdc,  vacuum was around 14 and my Daytona cam
has 218 at 50.

He suggested I switch to a 4-hole spacer rather than the open one I'm
currently using, and also thought I should move the timing to 14 or
15. He also wondered if I had good hot spark. Not sure how to check
that.

I asked about the power valve and he said it probably isn't even
opening as the vacuum would have to drop below 6.5 for that to happen.

I have power steering that uses vacuum as well as a pcv valve - do
those use up too much of the available vacuum?

I don't want to risk damaging my engine - are any of his suggestions
potential problems?

Thanks as always,
Brian Safford
62 Dart / Poly 318


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.