Re: 63 64 Dodge side moldings was vintage drag race videos

["Gary H." <spigot2039@xxxxxxxxxxx>]

The '63 Dodge at about “2:56” is a 440 model. 
http://www.youtube.com/watch?v=dWi5MfLbZT0

I agree a side-by-side comparison is probably best to answer the trim question. Or if you can find 1963 and 1964 parts books and see if they have the same part numbers? 

Thanks,
Gary H. 

-----Original Message-----
>
>Those were the good old days of drag racing! Love the white ’64 Dodge Polara but the red ’63 Dodge with the black side sweep (located on the timer bar at about “2:56”) raised a special interest to me (what model was it?). I’m also wondering, might anyone here know if the end profile contours of the’63’s side sweep molding might be an identical match to the side sweep molding of a ’64 Dodge Polara, 440 or 330 model? I do know that all the ½ inch wide SS moldings on all the ’64 models were the same just used in different configurations. I’m inclined to think the ‘63s may well be the same as the’64s but would like to know for sure. Tough question unless both model years are compared side-by-side. 
>Thanks,
>Dave B


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

u/?bUrDWg.bSONJP.YXJjLjYy



?p=TEXFOOTER