Re: Max Wedge

[Donnie Schanz Jr <dcs426@xxxxxxxxxxxxxx>]

To answer your question...Yes it will take 7200-7500 rpms. Mine has seen it 
a time or two, before the rev limiter. Now just because it will take it 
doesnt mean it makes power up there. Your camshaft choice will tell you 
where it should be run to. I run mine about 6500 or so with my cam.

Donnie
----- Original Message ----- 
From: "Christopher Gleffe" <customizeordie@xxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Friday, October 29, 2010 2:38 PM
Subject: Max Wedge



Hi folks,

I have a question - maybe somebody can help.

How much rpm´s does an Max Wedge engine can take (with the following parts):

Mopar Performance Max Wedge iron heads

Mopar Performance Cross Ram

TTI Max Wedge System

Are 7200-7500 rpm´s realistic #


--
GMX DSL Doppel-Flat ab 19,99 &euro;/mtl.! Jetzt auch mit
gratis Notebook-Flat! http://portal.gmx.net/de/go/dsl


----
Please address private mail -- mail of interest to only one person --  
directly to that person.  I.e., send parts/car transactions and negotiations 
as well as other personal messages only to the intended recipient, not to 
the Clubhouse public address. This practice will protect your privacy, 
reduce the total volume of mail and fine tune the content signal to Mopar 
topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and 
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

u/?bUrDWg.bSONJP.YXJjLjYy



?p=TEXFOOTER