Re: crankshaft key?

[Jimmy Peavy <peaver63@xxxxxxxxxxxxxx>]

Tap down on one end with a small hammer
That should "rock" it up on the other end, making it easier to come out.

-----Original Message-----
>From: "Gary H." <spigot2039@xxxxxxxxxxx>
>Sent: Jan 11, 2011 12:48 PM
>To: 1962to1965mopars@xxxxxxxxxx
>Subject: crankshaft key?
>
>
>Does anyone have a tip on how best to remove the woodruff key in the keyway in the crankshaft of a 318 Poly motor? The one that positions the lower timing chain gear. That key is *really* stuck in there!  (The crank is still in the engine.)
>
>Thanks,
>Gary H.
>
>
>----
>Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!
>
>1962 to 1965 Mopar Clubhouse Discussion Guidelines:
>http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 
>


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.