RE: '62 rear drums

[62pluckedchicken@xxxxxxxxx]

Thanks Paul.. I'll see if I can pass this on to Rob, brfore he takes a 
stab at it
Paul Lennemann wrote:
> 
> Here is the procedure I use with the correct puller.  Take the axle nut 
> off and put it back on backwards, turning it so it is flush with the end 
> 
> of the axle.  Attach the puller and tighten it down tight using a fist 
> maul.  Then rap the end of center screw with the maul.  Having the nut 
> on backwards ensures that the end of the axle won't mushroom out from 
> all of the pressure.  Doing this two or three times (sometimes just 
> once) will usually get it to pop loose. and when it comes loose it will 
> pop.
> 
> Paul L.
> '63 Sport Fury
> 440/727
> http://www.1962to1965mopar.ornocar.org/ml-lennemann63.html
> 
> 62pluckedchicken@xxxxxxxxx wrote:
> > 
> > Got your puller over to Rob.. he's gonna give it a shot tomorrow 
> > morning... keep your fingers crossed ;)
> > 
> > Thanks
> > Rich Kinsley wrote:
> > > 
> > > Probably would work but I have one you can borrow.
> > > 
> > > Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
> > > ======================================================================
> > > 62pluckedchicken@xxxxxxxxx wrote:
> > > > 
> > > > I can't find the puller in Gary's picture, but I did find this on a 300 
> > > > forum http://www.chrysler300club.com/rcmstuff/fairbanks/puller.html
> > > > 
> > > > has anyone tried this puller?
> > > > 
> > > > spigot2039@xxxxxxxxxxx wrote:
> > > > > 
> > > > > 
> > > > > There's a picture of the type puller used shown on the tech page. 
> > > > > 
> > > > > http://1962to1965mopar.ornocar.com/images/axlepullertm.jpg
> > > > > 
> > > > > I don't know if they are still made but I've seen used ones for sale at 
> > > > > swap meets.
> > > > > 
> > > > > Thanks,
> > > > > Gary H. 
> > > > > 
> > > > > -----Original Message----- 
> > > > > >
> > > > > >
> > > > > >I think he may have made his own puller... there is a puller listed on 
> > > > > >1962to1965mopar.ornocar.com?  
> > > > > >
> > > > > >Is it on the Vendor page? 
> > > 
> > > 
> > > 
> > > Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
> > > http://1962to1965mopar.ornocar.org/ml-kinsley64polara.html


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.