Re: Loooong rams in a B?

[Stan Kafouse <skafouse@xxxxxxxxx>]

they will be narrower. I thoght about also. The block is taller on an angle thus pulling each side closeras you go dowen on both sides the carbs will spread out

--- On Tue, 3/15/11, Roger Pettigrew <dodger7998@xxxxxxx> wrote:

> From: Roger Pettigrew <dodger7998@xxxxxxx>
> Subject: Re: Loooong rams in a B?
> To: 1962to1965mopars@xxxxxxxxxx
> Date: Tuesday, March 15, 2011, 6:19 PM
> 
> 
> Sorry  but have to disagree,,,, manifolds will be
> setting higher and  
> wider, not narrower
>  
>  
> In a message dated 3/15/2011 10:56:27 A.M. Central Daylight
> Time,  
> zephyr9900@xxxxxxxxxxx
> writes:
> 
> .   But the RB setup has the
> manifolds sitting higher and narrower over all. As 
> opposed to the same 
> setup
> on a B  block
> 
> 
> --
> [Non-text portions of this message have been removed]
> 
> 
> ----
> Please address private mail -- mail of interest to only one
> person -- directly to that person.  I.e., send
> parts/car transactions and negotiations as well as other
> personal messages only to the intended recipient, not to the
> Clubhouse public address. This practice will protect your
> privacy, reduce the total volume of mail and fine tune the
> content signal to Mopar topic.  Thanks!
> 
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and
> http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
> 
> 
> 
>