Re: Poly Block Update-Not So Great

[Ray Bell <raybell46@xxxxxxxxx>]

Not so, Dodger...

There are undersize bearings and there are oversize bearings. The
undersize bearings are to compensate for wear and re-machining of the
journals, oversize shells are for this purpose being discussed here.

They're not always available for all applications, however.

I would prefer to go with a fresh block myself. There must be scope
for finding one within a hundred miles or so?

No... I'm not volunteering to airfreight one of those I have here to
America!

Ray


On Jan 5, 5:06 am, Dodger7...@xxxxxxx wrote:
> over sized bearing still have the same external measurement
>
> In a message dated 1/4/2012 12:43:34 P.M. Central Standard Time,
>
> djohn14...@xxxxxxxxx writes:
>
> over sized bearing?
>
> DJ
>

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.