Re: Calvert Shock Users?

[Christopher Glick <mrchristopher1@xxxxxxxxxxx>]

Mike,

Curious about removing the bump stop for the upper control arm... help me understand as I am of the thought that with the bump stops installed there is less distance for the lower Control arm to travel before it is picking up the front end therefore tranferring the weight quicker.

 

...or am I way off here????

Christopher Glick

---

From: "mike creglow" <mcreglow@xxxxxxxxx>
To: 1962to1965mopars@xxxxxxxxxxxxxxxx
Sent: Thursday, March 8, 2012 10:02:59 AM
Subject: Re: Calvert Shock Users?

i'm running calvert shocks on front and back on my car with no
complaints.  i suggest that you make the front shocks as long as
possible by stacking washers on the bottom side of the inner fender,
and remove the upper control arm bump stops.  that will help with
weight transfer on launch.  refer to the following URL:

http://s596.photobucket.com/albums/tt41/mcreglow/?action="">
the calvert rear shocks are sourced from rancho.  i took a sharpie to
mark the notches on the shock.  otherwise they are hard to see when
adjusting at the track.

mike

>
>>  >I planning to pull the trigger and buy a complete set of Calvert shocks for my
>>  >'65 Belvedere.  12 flat car (almost) at a race weight of 3850.
>>  >
>>  >Anyone have any experience with them?  They're going to cost about $300 for the
>>  >four shocks and I don't want to spend it foolishly.
>
>>  >Akron Don Gallimore

--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.