Re: Need Exhaust Manifold Advice - Again

["Gary H." <62to65mopar@xxxxxxxxxxx>]

Perhaps this?

http://www.hotrod.com/techarticles/hrdp_1111_header_modeling_kit_build_pipe_dream/  


Thanks,
Gary H.


>  -------Original Message-------
 
>  
>  Yeh, I'm going to get a 110 mig welder oneday.  I think I'll
>  experiment then.
>  
>  On Mar 30, 8:49 am, Eric  wrote:
>  > I'm really surprised he couldn't cut them to make them a little bit shorter
>  > to drop down a 

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.