Radiator Question

[JimJablonski <groovinjim@xxxxxxx>]

Hey fellas (and ladies),

Been a while since I've posted but I'm finally in a place to resume
the Fury project.  Next up is getting the cooling system ready for the
stroker.  I was going to go with a Griffin after several thumbs up,
most notably from Tom Hecht (if you are still around, Tom, then hey
there).

Anyway, I looked into purchasing a Griffin and was told by Douggie
Houser parts guy (sorry to you younger lads) a few things that I would
like validated by the experts (you guys):

- Correct Griffin part number for my '64 Fury is a Griffin MaxCool
5-560HF-FXX which is 18' x 22" (?)
- This model is good to 600HP (which is a little scary given my plans
for the stroker should take me near 650)

Can anyone verify the above part number, and does anyone have
experience with the HP claim?

How about brackets and fitment suggestions?

An alternative to Griffin?  (I will look into BeCool but my experience
is BeCool = BigBucks)

Thank you in advance and hope all is well.

Jim

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.