Re: 8.75 Rear Yoke Swapping

[Jimmy Peavy <peaver63@xxxxxxxxxxxxxx>]

Well if you're talking about a 489 rear 8.75" , you have to replace the 
crush sleeve.
A 742 rear 8.75" uses shims, instead of a crush sleeve.

Jimmy

On 6/4/2012 2:21 PM, Bill M wrote:
> When you swap the yoke on an 8.75 rear, do you have to "set-up" the
> rear again with a new crush sleeve? Or can you just buzz the nut off
> and torque it back on?
>
> Thanks!
>
> Bill M
> 65 Coronet 500 'vert http://1962to1965mopar.ornocar.com/mmo62008.html
> 73 Dart Sport, 00 Cherokee Sport, 05 Ram 2500 CTD, 4WD, QC, LB, Laramie
> 21 Model T Depot Hack, 92 Accord, 06 Mazda 3

--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.