Re: Instrument cluster question

In a message dated 8/19/2012 7:15:23 P.M. Central Daylight Time, groovinjim@xxxxxxx writes:

Hi there folks,

Would appreciate your help solving a mystery, Behind my instrument cluster, right near the voltage limiter, is what I can only say looks like a condenser (from a points and condenser type of set). It has a black wire with a spade connector that is plugged into the center of the three holes where the voltage limiter is plugged in. It also has a red wire that is - well - snipped off.

Question is - what is this thing and more importantly, where does the red wire go? I can't seem to figure it out - at least it is not obvious. The only thing I could image is that at one time it was spliced into the red wire that connects to the ammeter. But those wires are long gone.

(I tried to add some pics with and without the voltage limiter connected.)

Please help!

Thank you,

Jim

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.