Re: Poly Stroker Machine Work-1st Steps

["tony.mokomoko@xxxxxxxxxxxxxxxxxxxxxxx" <tony.mokomoko@xxxxxxxxxxxxxxxxxxxxxxx>]

I'm in the same process. My block has been hot tanked, had all the rust taken out of the waterways. Had block and heads pressure tested .. and just about to get block sonic tested, and heads crack checked. Will keep you posted on next steps/developments.

On Tuesday, October 16, 2012 5:26:30 AM UTC+10, TopBanana wrote:
> I'm getting ready to get the machining done to my poly block and I'm a
> little rusty on everything to do. If I remember correctly, I'll need
> the following to get the block "ready for assembly"...
>
> Hot tank/Degrease
> Magnaflux
> Bore & Hone to 3.950" (from 3.910" = .040")
> Align Hone (do I need to do this??)
> Clearance for 4" stroker crank (if needed)
> Install New Cam Bearings
>
> Am I missing anything?
>
> Bill M
> 65 Coronet 500 'vert http://goo.gl/6xUS1
> 73 Dart Sport, 05 Ram 2500 CTD, 4WD, QC, LB, Laramie
> 21 Model T Depot Hack, 06 Mazda 3

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.