Dodger I’ve used this article for years when I’ve need info about 8 ¾ rear ends and always found it useful. They have the perch dimensions for 62-70 B body listed as being the same which I believe is true. But I see what you mean that they have the track listed in that same section as being the same too. Of course the track also depends on brake width and wheel width and back spacing. However if you scroll down to the bottom of the article where they list the part numbers for the various housings you’ll see they have the different flange to flange dimensions listed by year for the B body rears. From: 1962to1965mopars@xxxxxxxxxxxxxxxx [mailto:1962to1965mopars@xxxxxxxxxxxxxxxx] On Behalf Of Dodger7998@xxxxxxx I find this article upsetting,,,,,,, I read it word for word until it got down to dimensions,,,,,, why someone would go to the trouble to do this extensive a report on a part and then lump all B-Body rearends (62-70) as being the same width (I hope most of us know this is not true) and if they blew it on this set of numbers, why would I trust the rest to be correct?? In a message dated 12/23/2012 8:20:54 A.M. Central Standard Time, zephyr9900@xxxxxxxxxxx writes:
-- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. |