Re: Questions about '62 parts car

["Gary H." <62to65mopar@xxxxxxxxxxx>]

Did they look like this?

http://www.amazon.com/Floating-Power-Engine-Transmission-Mount/dp/B0068QHS1O

Thanks,
Gary H. 


>  -------Original Message-------
 
>  I can not say for sure on the early part, but I suspect so, I have had  two
>  62s  and one of them did have the floating type mounts in  it,,,,,,,
>  
>  
>  In a message dated 4/11/2013 10:06:19 P.M. Central Daylight Time,
>  hemirr...

>> The engine mounts   (318 poly) were the
>  "floating power" type.  Every other one I had contact   with had mounts
>  like a '63-'65, with an intermediate bracket between the flat   K-member
>  pads and the angled upper mounts.  Was this an early one, or was   it a
>  certain plant that used these mounts, or?  Just wondering. 

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.