Re: Welcome new member, 1964 Plymouth Fury

["Gary H." <62to65mopar@xxxxxxxxxxx>]

Indeed Jim!

Ell Dee, first thing I would do is pull the spark plugs and put a teaspoon of light oil like Marvel Mystery Oil in each cylinder and let it sit a few days with the plugs hand-tight. Then pull the plugs and try to hand turn the engine to see if it is stuck. 

Then check the brakes. You probably need to replace all the cylinders, hoses and maybe the shoes t/ hardware brake lines. Consider switching to a dual master at this time too.

So, the plan is to get the Fury to run then stop and go from there. As you proceed, ask specific questions in new emails with the question identified in the subject line of the email.

Thanks,
Gary H.
 

>  -------Original Message-------
>  From: Jim Auxier  
>  
>  Welcome Ell Dee Lots of information on this site great bunch of guys and
>  gals also. 

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.