Re: Adjusting front end suspension height
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Adjusting front end suspension height



1 3/4"?  You should be shooting for the 2".  Station Wagons are Suburbans.
 
 
 
 
-------Original Message-------
 
Date: 10/31/2013 12:25:44 PM
Subject: Adjusting front end suspension height
 

Figured it is a good idea to record before dimensions of my ’62 wagon front end before tearing into it.  Going by the service manual, is it saying to measure from the lowest point on the torsion bar adjuster nut plate??

 

Because measuring from the floor to there, and subtracting the measurement from the floor to the lowest point on the outer tie-rod, does not get anything close to the 1 ¾” specified.  More like 4”.....  She will be quite the low rider if I set it to 1 ¾”.

 

I also recorded as is measurements to the wheel well openings at the center-line of the wheels, she does list a bit to the starboard side.  Goes along with the boat like ride.  ; )

 

Left front:             26.5” 

Right front:           26.125”

 

Left rear:              24.125”

Right rear:             23.75”

 

F:/Incredi Mail/IM/Runtime/Message/{E4EC7864-0EA7-4BD7-98E2-0A7F0655757E}/Reply\image0011.png

 

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
 
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.