440 MW CAM AND PISTON CHOICE RECOMMENDATIONS NEEDED.....

[BCBOUND <bcbound1@xxxxxxxxx>]

Im looking for recommendations on piston choices and camshafts for the 440 MW Crossram motor I am currently building.

I have 2 sets of TRW pistons....11.5 pop ups and flat tops.  I am using MP repro MW heads with the bolt on rocker stands and 4 bolt VC's.  Anyone know the chamber size of these heads?  They were new about 10 years ago and then discontinued, not sure why.

Anyway will there be a big difference in street/strip driving between the  two pistons?  I would like to use pump gas, maybe with a 5 gallon shot of race gas to a full tank of 92 octane. Will this be enough to run the 11.5/1 pistons?

Which cam are you guys using or recommending? Will it work with either piston choice?

Again, thanks in advance.

Ralph Hornbeck

BCBOUND

San Diego  (Sandy Ego)

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
 
--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.