Re: Broken 742

[JimJablonski <groovinjim@xxxxxxx>]

Evening fellas.  I usually hesitate to speculate on some of these posts with the limited data available, but let me throw something out there.  One area I've consistently seen neglected is to check to make sure your rear is perfectly perpendicular (square) to the centerline of your chassis.  Particularly on our cars where this wasn't perfect right from the beginning.

There are many ways to do this, but it is not rocket science.  A few plumb bobs and string and you are good to go assuming you can articulate the basics of a 3/4/5 triangle.

Looking at the setup of your car where obviously someone made mods to what was already famously imperfect geometry from the factory, I submit to you that it's plausable for a misaligned rear to chew that ring gear on hard launch.

Thank you,

Jim

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/d/optout.