Re: 1965 rear wheel stud part #?

[Ray Bell <raybell46@xxxxxxxxx>]

If I may, I'll give you a tip about ensuring the studs are right in when you get that far...

Get some washers or an oversize nut or two (¾" thread perhaps, maybe an old castellated nut from a front stub axle) and a normal ½" UNF nut, possibly a wheel nut but turned backwards so you have flat surface against flat surface between the nuts and or washers.

Put the stud in place, tap it in most of the way, fit up packing washers or nuts, screw on the nut and begin tightening. The purpose of this is to put tension on the stud as you hammer the back so it is inspired to go fully home.

You will find it beneficial when doing this to turn the bearing retaining flange so the flat is towards the side where you're swinging your hammer, or maybe a drift would help. Tighten the nut, give it a whack, tighten some more and so on until you're satisfied it's fully pushed in.

Ray

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.