Re: 1962 Rear Spring Mounts Reinforcement

[Bill Whittaker <whittakers@xxxxxxxxxxxxxxxxxxx>]

Strengthening the rear shock mounts isn't that difficult. I'm going to run air shocks so I needed to reinforce this area.  All I did was cut a section out and replaced it with 2x2 square tubing frame rail to frame rail.

Also, you don't need the "Z" or fancy cutting on subframe connectors.  I did mine with 2x3 tubing. The rear slides into the frame rail and the front welds to the torsion bar/trans crossmember. Nothing to it.

Al

On Wednesday, January 25, 2017 at 12:08:46 PM UTC-6, hmse...@xxxxxxx wrote:

 What have you Guys done with the rear spring mounts. The Back one are just a Sheet Metal weldment the is not very strong ?
 

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.