more aftermarket gauge questions.

[neal zimmerman <neal.zimmerman@xxxxxxxxx>]

In my original dash there was one pin on the circuit board that ran 2 little  lights for the factory  gauge cluster  lights.  Now there are three little SW gauges I have cleverly tucked in that space (wanted to keep dash looking stock at least at first glance). I also have an oil pressure gauge in the original mileage minder hole ( basically  it was a vacuum gauge) Would the wire that ran those two factory lights be enough  to run four  lights of the new gauges? 

   Or is there a better way?

   Hope this make sense.

  neal

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.