Re: steering coupler question

[mre842006 via The 1962 to 1965 Mopar Mail List Clubhouse <1962to1965mopars@xxxxxxxxxxxxxxxx>]

I had the same issue and I trimmed the gasket so the clips could be bent slightly to grip better. I notched around where each clip was and you could not see as the metal covered the areas i cut and i still sealed completely  I made sure it was good and clean where the clips catch and this worked for me.

Mike

On Thursday, July 6, 2017 at 1:36:25 AM UTC-4, neal wrote:

Anybody know how to get the 8 pronged plate on the coupler to actually GRAB the coupler pot. I got a new kit and the plate basically seems like gaskets too thick or the prongs are too short.

    neal

Virus-free. www.avg.comhad

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.