Re: Drive Shaft

There may be a listing of lengths on the club website, but if I'm remembering right, when I switched from a 727 to a T10 4 speed changeover out of a junkyard '63 in my old '62 Belvedere way back in '73, I was able to use the same driveshaft. Of course if you are changing to a later 4 speed it will have to be changed to a slip in yoke shaft.

Bill & Kathi Parker, South Central Indiana

On Fri, Jul 28, 2017 at 1:45 PM, Iwasa4dr <j.macgill@xxxxxxxxxxx> wrote:

Does anyone know if a 63 Savoy automatic driveshaft is the same length as a 4 speed. I am in need of a driveshaft for a 4 speed?

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.