Re: upsizing to 5 on 4.5

[Ray Bell <raybell46@xxxxxxxxx>]

Don't forget the option of using Australian A-body parts...

The 5 on 4.5" pattern was used here from 1971 to 1981, but with a bigger stub axle and wheel bearings (these were changed after endurance attempts found the weakness in the old wheel bearing size), so you need spindle and all.

Both drum and vented disc options are plentiful here.

By the way, I understood your A-body cars went over to 5 on 4.5" about 1973 or '74.

Ray

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.