Re: Just finished Diamond Hone on the Poly block....

[JimJablonski <groovinjim@xxxxxxx>]

Hi Gary,

Happy Easter.

Out of curiosity, the honing was completed prior to the decking?

Jim

On Sunday, April 1, 2018 at 12:44:45 AM UTC-4, glpav...@xxxxxxx wrote:

Thank you; credits go to my engine builder friend Gregg Hekimian who did the diamond hone w/profiliometer readings then had an experienced machinist (old-timer perfectionist) square & deck the block with a specified mill .

Gary P.

 

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.