I am trying to install TTI Headers on a 318 Poly in a 1964 Plymouth Belvedere. Finally I have all of the header bolts in except one and that one is getting close to impossible. It is the lower bolt of cylinder #5 which is the third one on the driver's side. I can get it in the hole but so far I have not found a way to turn it with my fingers or any tool to get it started. I am using the bolts that came with the headers. Even though I really don't want to I have considered pulling the header back off of the driver's side and installing studs in the difficult locations.
I am working on jack stands so I have limited ways I can get my hands up the the header flange. Any and all suggestions will be appreciated.
Thanks
Dennis C.
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!