|
|
Board Moderator & Exner Expert 10K+
Posts: 13049
Location: Southern Sweden - Sturkö island | For to remove the pulley from the power steering pump without any damages a special puller is needed.
This is my homemade puller consisting of 5 different parts.
It took me some time to make it, turning the parts in the lathe, welding the parts together with TIG, but the removal of the pulley went extremely smooth.
I'll post some pictures of the other tools I made for the pump as I start to renovate the pump.
(Pulley_Puller_1.jpg)
(Pulley_Puller_2.jpg)
(Pulley_Puller_3.jpg)
(Pulley_Puller_4.jpg)
(Pulley_Puller_5.jpg)
Attachments ---------------- Pulley_Puller_1.jpg (188KB - 194 downloads) Pulley_Puller_2.jpg (233KB - 204 downloads) Pulley_Puller_3.jpg (229KB - 211 downloads) Pulley_Puller_4.jpg (221KB - 220 downloads) Pulley_Puller_5.jpg (222KB - 215 downloads)
|
|
|
|
Board Moderator & Exner Expert 10K+
Posts: 13049
Location: Southern Sweden - Sturkö island | The pulley has spent some time in my Strip-All bath
Strip-All is a product from Drake Chemicals in Norway, removes all, paint and rust.
Sorry, this page is in Swedish http://www.strip-all.com/se/ |
|
|
|
Expert 5K+
Posts: 8443
Location: Perth Australia | Nice work as always Sven
Might have to make one as well
|
|
|
|
Board Moderator & Exner Expert 10K+
Posts: 13049
Location: Southern Sweden - Sturkö island | Next set of tools;
(Shaft_Needlebearing_Puller-1.jpg)
(Shaft_Needlebearing_Puller-2.jpg)
(Shaft_Needlebearing_Puller-3.jpg)
(Shaft_Needlebearing_Puller-4.jpg)
(Support-1.jpg)
(Support-2.jpg)
(Ferrule_Socket-1.jpg)
(Ferrule_Socket-2.jpg)
Attachments ---------------- Shaft_Needlebearing_Puller-1.jpg (206KB - 216 downloads) Shaft_Needlebearing_Puller-2.jpg (267KB - 204 downloads) Shaft_Needlebearing_Puller-3.jpg (252KB - 199 downloads) Shaft_Needlebearing_Puller-4.jpg (290KB - 207 downloads) Support-1.jpg (246KB - 202 downloads) Support-2.jpg (128KB - 199 downloads) Ferrule_Socket-1.jpg (188KB - 205 downloads) Ferrule_Socket-2.jpg (200KB - 206 downloads)
|
|
|