IML: 63 wheel locking question

["bom tie" <bomtie@xxxxxxxxxx>]

Ok, my car has been non-driving for 2 years, I have run the engine. I have had to pull it with the truck to move it around the shop. I rebuild all the brakes but the car still doesn't want to budge. I traced the resistance to the rear drivers side, so i pulled the drum backed the brakes off a bit and sanded all rust from both surfaces. The drum went on easy, I had high hopes. NOW, the wheel turns easy for awhile then gets very hard. No rime on reason here; might turns easy for 1, 3, 4, or 7 turns then go hard. THEN, when I reverse direction it may be easy or hard. AND when it is hard it may stay hard or go easy again.
Thanks for the ideas,
Charles

_______________________________________________
Join Excite! - http://www.excite.com
The most personalized portal on the Web!




-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm