Re: IML: iml 60 brake light switch/fuse?/also...

>>i checked the feed at the m/c and found power, umm.. direct wired
>>the b/l wire but still no >brake lights ? i checked the bulbs and
>>found ok ! - had another look at fuse board ,but nowt >found.
>
>If you have power at the master cylinder then you can leave the
>fuses be.... The m/s is down line from the fuse block.yes live.
>
>>
>>surley there must be a relay or fuse box for the elec windows and
>>head/tail/brake lights ???
>>
>
>High draw devices use circuit breakers tht reset themselves.  Brake >lights are not a high draw item.ok

>
>Turn signals are working?  If they are working then the next place I
>would suspect would be the turn signal switch.why?
>
>>
>>re m/c - found that brake fluid is leaking from top of m/c when
>>brakes applied ? air in system ?
>>
>
>There should be a piece between the lid and master cylinder that
>acts as a gasket.  It is the size of the lid and has a hole in the .
>middle for the bolt to go through.gasket is in place
>
>        i shall check tommorow , gud nite all.     Steve
>
>
>
>-----------------  http://www.imperialclub.com  -----------------
>This message was sent to you by the Imperial Mailing List. Please
>reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
>shared with everyone. Private messages (and attachments) for the
>Administrators should be sent to iml.webmonster@xxxxxxxxx
>To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
>