Re: IML: Tranny fluid for a semi-automatic

["Bill Watson" <wwatson5@xxxxxxxxx>]

The 1946-48 Chrysler Shop Manual says to use 10W motor oil in the
semi-automatic transmission.

The Fluid Drive is actually the fluid coupling between the engine and the
clutch and is not part of the transmission.  In the 1946-48 manual, the
Fluid Drive is convered in section IV with the clutch.

Bill
Vancouver, BC



----- Original Message ----- 
From: Imperial48@xxxxxxx
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Tuesday, December 07, 2004 9:57 PM
Subject: IML: Tranny fluid for a semi-automatic


Any suggestions as to what Transmission fluid on today's market should be
used in a 1948 semi-automatic?  (Fluid Drive)

I'm also still looking for a center carrier bearing replacement or repair.

Ned     '48 Crown Imperial



-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm