The Ammeter on the '60 Imperial is not part of this system. Only the
Oil Pressure, Temperature, and Fuel. Since your Fuel and Oil Pressure do not
seem to work, it is possible that the jumper wire from the power output side
of the Temperature gauge has become disconnected. I think you need to pull the
cluster and check for loose connections.
The oil pressure sending unit is mounted on the top side of the back
of the motor by the fire wall. It might be easier to replace that, and see if
your Oil Pressure gauge comes up before pulling the cluster. For me either job
is just about the same amount of work. Depends on whether your prefer under
the hood or under the dash.
Paul W.
-----Original Message-----
From: Tom Scott
<shelbyguy@xxxxxxx>
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Wed,
14 Dec 2005 16:20:41 -0500
Subject: Re: IML: Attn: Tom Scott (was re:
Gauges )
David,
Fuel guage is stuck on E
Oil pressure guage on 0
Ammeter and H2O temp work fine
Tom
----- Original Message -----
Sent: Wednesday, December 14, 2005 3:50
PM
Subject: Re: IML: Attn: Tom Scott (was
re: Gauges )
It makes a difference what you mean by "inop". Is
the gauge stuck on E or F?
If on F, you probably have a short in the wiring.
Happy motoring,
Happy motoring,
David
'91 K-Imperial
driver
'66 Crown Coupe project
'66 LeBaron dual air and every option
known to man
Back to the Home of the Forward Look Network