It has been many years since I purchased one, but I used to buy the external voltage limiters at the local Chrysler Dealer. I think someone posted something about a similar part being available through NAPA. I hope that is helpful.
Thanks a lot Paul!
Can I simply use an electronic voltage regulator of 5 V then (you know, a
so called Integrated Circuit like the 7805 ?)
Or is there a official replacement part available?
If so, do you know (or anyone else on the list) a company that sells them?
Thanks,
Robert
Op Di, 9 mei, 2006 4:31 pm, schreef randalpark@xxxxxxx:
> Do not operate your car's ignition until the gauges are either
> disconnected or this is repaired. You are correct that the voltage
> limiter has failed. Continued use will burn them out. The fix is the same
> for this as the '61 through '63 models. I don't remember which gauge
> contains the limiter, but it will be obvious once you pull the cluster.
> The power input goes to that gauge. The new limiter is added, and
> grounded to the cluster (or someplace else that is convenient) through a
> mounting screw, then just hook up the wires using the new limiter instead
> of the original built in one.
>
> Paul W.
>
>
> -----Original Message-----
> From: Rob van der Es <r.vdes@xxxxxxxxxxxxxxx>
> To: mailing-list@xxxxxxxxxxxxxxxx
> Sent: Tue, 9 May 2006 07:25:32 +0200 (CEST)
> Subject: IML: 1960 gauge question
>
>
>
> Hi All,
>
>
> I have a question with regard to the instrument cluster of my 1960
> Imperial Crown.
> All of the sudden my instruments are showing max. values (oil pressure,
> fuel,temperature) so I think my gauge voltage regulator/limiter is
> defective.
>
> Am I right about that? And if so, where is the limiter situated in a 1960
> Imperial?
> Can I replace it with a modern solid state voltage regulator (like the
> 7805 IC)?
>
>
>
> Anyone out there who can shine a light on it?
>
>
> Thanks in advance,
>
>
> Robert
>
>
>
>
> ----------------- http://www.imperialclub.com -----------------
> This message was sent to you by the Imperial Mailing List. Please
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared
> with everyone. Private messages (and attachments) for the Administrators
> should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to
> http://imperialclub.com/unsubscribe.htm
>
>
----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
Back to the Home of the Forward Look Network