Re: IML: Charging system
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: Charging system



The issue with your turn signals at slow idle leads me to think you may still have a charging issue. Again, I think it is related to a poor ground someplace, or other type of bad connection. The alternator should put out enough power for the turn signal to operate at a constant rate even at low rpm.
 
See if your dash lights come on again the next time you turn on the lights. One of the needles in one of the gauges could be shorting out after a time, shutting down the system. That problem should be pretty easy to isolate and fix.
 
Paul W.
 
 
-----Original Message-----
From: DReese@xxxxxxxx
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Thu, 5 Oct 2006 10:26 PM
Subject: RE: IML: Charging system

Thanks all for the input.  I'm crossing my fingers that the Imp is finally 
driveable - oops I just jinxed it.

I used the Imperial to run some errands and take a little drive around town just 
to see how everything was working and what problems might show up.  It seems to 
be charging the battery, I'm going to run an electrical test on it this weekend.  
I had the headlights on all the while, everything seems fine.  I mentioned the 
ammeter never ticking over to the "charge" side....well that changed when I 
adjusted the power seat, it showed a charge then.  Man, that seat motor draws 
some current!

Unfortunately the electroluminescents went out sometime while I was letting it 
idle last night.  Darned car, if it's not one thing it's five others. *sigh*  
However, the power antennae works wonderfully....it's hooked up to a radio that 
needs new tubes and both speakers have disintegrated, but the antennae works.

One odd thing, and this was going on before the new wiring harness and 
alternator: the turn signal works normally as long as I keep the rpm's up, say 
600+.  However when I'm stopped at an intersection with the brakes applied, the 
signal slows a lot and frequently just stops blinking.  If I use my left foot on 
the brake and raise the engine speed a tad, the signal picks up speed.  I have a 
new "blinker" but haven't installed it.  Anyone have an idea what that could be 
a symptom of?

Applying the brakes cuts the engine idle some as well.  I suspect I'm leaking 
vaccuum somewhere - another item to repair.

Thanks all again,
Donn Reese
1960 Custom 4dr HDTP







-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm

Check out the new AOL. Most comprehensive set of free safety and security tools, free access to millions of high-quality videos from across the web, free AOL Mail and more.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.