i checked the feed at the m/c and found power, umm.. direct wired the b/l wire but still no >brake lights ? i checked the bulbs and found ok ! - had another look at fuse board ,but nowt >found.
If you have power at the master cylinder then you can leave the fuses be.... The m/s is down line from the fuse block.
surley there must be a relay or fuse box for the elec windows and head/tail/brake lights ???
High draw devices use circuit breakers tht reset themselves. Brake lights are not a high draw item.
Turn signals are working? If they are working then the next place I would suspect would be the turn signal switch.
re m/c - found that brake fluid is leaking from top of m/c when brakes applied ? air in system ?
There should be a piece between the lid and master cylinder that acts as a gasket. It is the size of the lid and has a hole in the middle for the bolt to go through.
Steve
----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
Back to the Home of the Forward Look Network
Copyright © The Forward Look Network. All rights reserved.
Opinions expressed in posts reflect the views of
their respective authors.
This site contains affiliate links for which we may be
compensated.