Re: IML: Exhaust System Picture Needed

["RODGER D. REDDISH" <FltSgt@xxxxxxx>]



Hola

 

I now have a set of 1972-78 Dodge Truck Exhaust manifolds on the engine since they are the better flowing center dump fitting HP design, with an cross-over tube and resonators at the rear tail-pipe section on the 62. Note: no front muffler since resonators are used.

 

For the almost the same 66 I use the OEM exhaust manifolds of 1966, an "X" about the location of the front mufflers, The same part number OEM 1969 MoPar Performace Mufflers as use on the 62 car and the same part number resonators on the tail-pipe section.

 

The next time the local   http://southerncoloradomoparsorg/  has an "Dyno Day" and gets an discount at the Dyno Shop, I'll know the true rear wheel power of the "country club quite" 62.

 

Rodger & Gabby

COS

 

 

----- Original Message -----

From: Mark Evans

To: mailing-list@xxxxxxxxxxxxxxxx

Sent: Wednesday, July 25, 2007 6:06 AM

Subject: Re: IML: Exhaust System Picture Needed

Graham,
Exhaust bending instructions are on the website at:
    http://www.imperialclub.org/Repair/Exhaust/ExhaustBendingDirections/

Also, on the '63 page, you'll find a parts book with a nice "topology"
of the layout:
    http://www.imperialclub.org/Yr/1963/PartsBook/Exhaust-Dual.htm

Hope that helps.
--MarkE

-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm