Re: IML: Oil usage theories
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: IML: Oil usage theories
- From: "Gary Wilson" <mopar413@xxxxxxxxxxx>
- Date: Tue, 13 Nov 2007 19:24:30 -0800
If you have oil on the treads it almost has to be leaking from the valve
cover gaskets. If the tips are dry and clean it can';t hardly be anything
else.
----- Original Message -----
From: "Steve B." <Imperial59@xxxxxxxxxxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Tuesday, November 13, 2007 5:46 PM
Subject: Re: IML: Oil usage theories
Compression check months ago was OK, no blue smoke at cold start up (even
if sitting for days), no blue smoke at hard acceleration, or after idle -
just no blue smoke at all. Idles and drives quite well, gets about 11
mpg. Pulled the plugs yesterday after 3000 miles, and they were nicely
tanned/greyed, clean everywhere except wet oil on the threads.
Dave had mentioned earlier that big block Mopars have a tendency to need
valve seals. If that is what's indicated by the above evidence, I could
probably find the resources to pull the heads.
Dan:
You probably do need valve seals as most engines do at this age, but I
don't think they are your problem. You've seen the Chrysler minivans
around town that look like mosquito foggers with all the blue smoke coming
out the back? Well they aren't using the kind of oil you are using...
Failed valve seals let the oil in to the combustion chamber, if you were
actually burning that much oil there would be clouds of oil behind you and
those plugs would have been black clumps of goo instead of nice and brown.
From your description of the plugs it doesn't sound like you are burning
much/any oil.
You most likely have a leak somewhere. Valve cover gaskets (wet oil on
the plug threads suggest they are leaking), oil pressure sending unit,
rear main seal... I don't know where it is but I don't think it is a
valve seal problem. Try putting some cardboard under the car and rev the
engine to hiway rpm for a few minutes and see if you can see anything
leaking.
Steve B.
----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please reply to
mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with
everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
Back to the Home of the Forward Look Network