-------------- Original message --------------
From: "Rob Kidd" <rlkidd@xxxxxxxxxxxxxxxx>
> So, maybe George should reproduce these lenses and include
> a correct type of white LED bulb with the lense purchase?
>
>
>
> On Wed, 16 Jan 2008 08:29:54 EST
> HOFCAG@xxxxxxx wrote:
> >Thanks to George, Phil et al for your suggestions.
> > George, I did remove the
> >assembly and fiddled with it a bit, but cannot seem to
> >free up the switch.
> >If I push REALLY hard the switch will move, but I'm afraid
> >I'll totally ruin
> >it if I do that often. Is there some type of lubricant I
> >can use? Also, I
> >was wondering if the lens could be reproduced in glass?
> > That would eliminate
> >the problem of the heat produced by the large bulb causing
> > the plastic lens
> >to soften & warp......but would it cause too much heat to
> > build up? The woman
> >who owns a local glass shop told me she had some sort of
> >ultra high speed
> >drill that could drill screw holes in a small piece of
> >thin, tempered glass.
> >She thinks she could use the plastic lens as a template.
> > Any opinions?
> >
> >
> >
> >**************Start the year off right. Easy ways to stay
> >in shape.
> >http://body.aol.com/fitness/winter-exercise?NCID=aolcmp00300000002489
>
>
> ----------------- http://www.imperialclub.com -----------------
> This message was sent to you by the Imperial Mailing List. Please
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
> shared with everyone. Private messages (and attachments) for the
> Administrators should be sent to iml.webmonster@xxxxxxxxx
> To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
>