I actually viewed an older Bentley where the instructions on the firewall for tuning.. a coin.was used.(don't ask which one) If you couldn't get it to balance..you had to go thru the whole procedure again. So I am not so sure it is "only a trick" ----- Original Message ----- From: Dick Benjamin Sent: Sunday, December 22, 2002 9:50 AM To: mailing-list@xxxxxxxxxxxxxxxx Subject: Re: IML: Balancing trick (was 63 Turbine Car) This is a car show trick demonstrated by many people to show off how smooth their engine is.
I have done it myself on my 47 Packard limousine, to amaze my grandkids. What no one will tell you is that there is a trick to it: you have to position the nickel such that the engine vibration is in the direction to make the nickel roll back and forth (a tiny amount, but never the less, important). If you try to stand the nickel along the front to back line of the engine, it will vibrate and fall over sooner or later. If you position it across the engine, it will sit there forever (as long as the engine is in a good state of tune) and look like it is stationary to the eye, but actually, it is rolling microscopically.
Fun trick, though. Dick Benjamin ----- Original Message ----- From: "Bob Smith" <limoguy1950@xxxxxxxxx> To: <mailing-list@xxxxxxxxxxxxxxxx> Sent: Saturday, December 21, 2002 1:28 PM Subject: IML: Balancing trick (was 63 Turbine Car)
> > Ask Dick Benjamin: The following could be (and was) done with most of the old Packard 8s in thge 30s and 40s. > Bob > Chris Boekhout wrote: : > > > One of the demonstrations they perform with the car is this nifty > > little > > trick : With the engine IDLING at 20,000 rpm, they place a nickel on top > > of > > the engine, standing on edge- the engine is so vibration free that the > > nickel does not fall over, very impressive piece of machinery. > > > > Chris > > > > 72 Lebaron > > 71 Lebaron,etc.etc > > > > > > --------------------------------- > Do you Yahoo!? > Yahoo! Mail Plus - Powerful. Affordable. Sign up now
----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
|