Mity Vac brake bleeder or using your compressor
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Mity Vac brake bleeder or using your compressor



I did the following on the 1960, and it worked well.  I got razzed by a couple of guys here, but it worked for me, so here's the scoop:
 
Mity Vac is a squeeze pump that has a dial vacuum gauge.  I had bought it to see if I could locate the vacuum leak on a Lincoln that had vac operated headlight doors.
 
To bleed brakes, I bought 15 feet of clear surgical style plastic tubing at the hardware store, taking one of the bleeder nipple/bolts out of a wheel cylinder and getting the size that fit right over the bleeder where the rubber cap normally sits.
 
I filled the brake reservoir.  I reinserted the bleeder bolt into the wheel cylinder and attached the hose to the right rear wheel cylinder and left the bleeder bolt in the open position, the other wheels closed.  the right rear wheel goes first as you want to work from farthest point away from the master cylinder and then work each cylinder that is  progressively closer to the Master Cylinder.  When on the front, do the lower cylinder first, as it is farther away from the MC than the top one.
 
Once attached at the wheel, the hose was thrown up and over a rafter and draped back down where I connected the Mity Vac and proceeded to suck the brake fluid through the lines until the fluid came out and started to fill the hose.  Cranked the bolt shut and repeated at all points, working on each successively closer (to the MC) bleeder screw.
 
I had to bleed each point the standard way when the system was full, as some micro bubbles of air were sucked past the loosened threads of the bolt, but that was a 5 minute thing, as there was very little air to purge.
 
Worked great for me.
 
_________________________________
 
So what did the guys that razzed me say worked better?!!??
 
Check this out:  Get a spare MC lid and insert a shrader valve into it, sealing well - just like on your car's tire.  Fill MC and Install lid and force the juice through with air, once again opening the bleeder bolts working from farthest to nearest.  Check fluid level regularly or risk blowing air through if the reservoir empties out on you.  I think that my system had to be refilled 3-4 times as the fluid evacuated into the lines. 
 
I did the pull method.  I sure liked the push method idea and will try it on the next system that I do.  I'd say that either one will get you to the same place. 
 
 


Kenyon Wills          
San Lorenzo/SF Bay Area
 
 
1973 Chrysler Imperial  --   >http://imperialclub.com/Yr/1973/Wills/index.htm
 


Do you Yahoo!?
New Yahoo! Photos - easier uploading and sharing

Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.