392 Rebuild Advice?

Hi all,I'm Ken,I use right front and left back intake bolt holes.I also use long hardened bolts and washers to lift the motor and tranny.Please get an extra set of hands to help guide the two assemblys,its neccary.-- Original Message -----

From: Brad Hogg

To: mailing-list@xxxxxxxxxxxxxxxx

Sent: Friday, January 30, 2004 7:09 PM

Subject: Re: IML: 392 Rebuild Advice?

Intake works for me.

----- Original Message -----
From: "mENTALmOPAR mAN" <collyman1@xxxxxxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Friday, January 30, 2004 5:11 PM
Subject: RE: IML: 392 Rebuild Advice?

Speaking of pulling engines:
I was hoping someone could give me a clue as to the best way to hoist an
engine and tranny out of my car. I have the front clip removed. and I just
need to know the best places to bolt the hoist to lift the engine and tranny
in one piece. Should I use the intake manifold bolts or a water pump bolt
and someting at the back of the motor (pump is already off) ????........
It's a '60's 413 and tranny.
Thanks for all the GREAT advice I always get here !!!!
Michael Howlett
Portland Oregon
too many cars............

----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm